Search Engine: Elastic

Article ID: 128487, created on Feb 29, 2016, last review on Jul 14, 2018

  • Applies to:
  • Odin Automation Essentials


Installation of the Odin Automation interrupts with the following warning:

"Warning! The firewall cannot be configured, because the conntrack module either is absent from the Linux kernel or its use is not allowed. If you want the firewall to be configured automatically, abort the installation and fix the issue with conntrack (vizit for details), before launching the installation again. Otherwise, proceed with the installation and configure the firewall later.

Do you want to continue the installation? [y/N]:"


As the conntrack module is used by Odin Automatin firewall, it must be present in the Linux kernel and should be enabled. The most common reason for this issue, is that the Odin Automation management node is being deployed inside a Virtuozzo container, where the conntrack module is disabled by default.


Abort the installation of Odin Automation. Open console on the harware node and shut down the container allotted for the Odin Automation managemnet node, using the following command:

#vzctl stop %container_ID%

Enable conntrack by running the command below:

#vzctl set %container_ID% --netfilter stateful --save

Start the container:

#vzctl start %container_ID%

After that, enter to the container and run the Odin Automation installer.

Note: more info on iptables modules in Virtuozzo containers can be found at:

d29f8259a7236d291b08be8147a45abd caea8340e2d186a540518d08602aa065

Email subscription for changes to this article
Save as PDF