Search Engine: Elastic

Article ID: 126125, created on Jul 9, 2015, last review on Dec 28, 2017

  • Applies to:
  • Plesk Automation


Migration failed during the infrastructure checking. There is the following error in debug.log

The following command has failed:
Command the migrator tried to execute on PPA service node 'PPA-WEB-LINUX-Test' (#5, was: /usr/bin/rsync -e 'ssh -i /root/.ssh/id_dsa.LttONKPw -o StrictHostKeyChecking=no' --archive root@ /tmp/check-rsync-testfile-web
exit code: 12
stderr: rsync: Failed to exec ssh: Permission denied (13)
rsync error: error in IPC code (code 14) at pipe.c(84) [receiver=3.0.6]
rsync: connection unexpectedly closed (0 bytes received so far) [receiver]
rsync error: error in rsync protocol data stream (code 12) at io.c(600) [receiver=3.0.6]


SELinux is enabled on the destination service node:

[root@PPA tmp]# cat /etc/selinux/config

# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
#     enforcing - SELinux security policy is enforced.
#     permissive - SELinux prints warnings instead of enforcing.
#     disabled - No SELinux policy is loaded.
# SELINUXTYPE= can take one of these two values:
#     targeted - Targeted processes are protected,
#     mls - Multi Level Security protection.


Disable SELinux with the following steps:

  1. Modify the /etc/selinux/config file as it is shown below:

  2. Run the following command:

    setenforce 0
  3. Reboot the server to apply changes.
  4. Restart the transfer process, wait for migration to finish.
  5. After migration processed, switch SELinux back to 'enabled' if needed:

    setenforce 1

e0aff7830fa22f92062ee4db78133079 caea8340e2d186a540518d08602aa065

Email subscription for changes to this article
Save as PDF