Search Engine: Elastic

Article ID: 116534, created on Jul 23, 2013, last review on Jul 14, 2018

  • Applies to:
  • Operations Automation 6.0
  • Business Automation


There are no resources available for upgrade/downgrade in CCP, following message is shown:

You have no resources available for upgrade/downgrade. Click "All Resource Usage" to get information on resource usage.


No Resources available

but these resources are present in the service plan the subscription is based on.

This is how the list of available resources in a subscription should look in the customer control panel:

Your text to link here...

When a customer clicks the 'Upgrade Resource Limits' button or follows the link 'Buy Additional Resources', they can only see and upgrade the three resources listed above.

At the same time, the provider's control panel shows the following list of resources, including some which are absent in the customer control panel:

Your text to link here...

As you can see, the customer cannot see resource usage and cannot upgrade some resources in their subscription, despite the fact that the resources are present in the Business Automation (BA) service plan and the resources are shown in subscription properties in the provider's control panel.


There are several possible causes:

  1. The 'Show in CP' parameter is disabled for the corresponding resource rates in the service plan.
  2. Resources were added to the service plan after the subscription was created and were not synced to the subscription.
  3. Resources are not included to any resource category in BA.
  4. Resources the customer does not see are based on KAGATE and are not supposed to be purchased with the standard upgrade wizard.


Problems #1 and #2 from the list above can be resolved with the following steps:

  1. Log in to the BA Provider Control Panel.
  2. Go to Product Director > Plan Manager > Service Plans (BA 5.4) or Home>Products>Service Plans (BA 5.5. and later).
  3. Click on the Service Plan the problem customer subscription is based on
  4. Switch to the 'Resource Rates' tab
  5. Make sure that the required Resource Rates are present in the Service Plan
  6. Click a Resource Rate which is absent in the Customer Control Panel
  7. Enable the 'Show in CP' parameter if it is not enabled
  8. Click the 'Synchronize' button
  9. Check the 'Update prices' option
  10. Click 'Synchronize'

For problem #3, use the following steps:

  1. Log in to the PBA Provider Control Panel
  2. Go to Product Director > Resource Manager > Resources in BA 5.4 or Home>Products>Resources in BA 5.5 or later
  3. Click on a resource which is absent in the Customer Control Panel
  4. Click 'Edit'
  5. Select the desired value for the 'Resource Category' parameter
  6. Click 'Save'

For problem 4 no steps are required, the customer is supposed to purchase license resources from the additional tab from CCP Odin Panel> Account> Subscription Management> susbcription id > Licenses

198398b282069eaf2d94a6af87dcb3ff caea8340e2d186a540518d08602aa065 e12cea1d47a3125d335d68e6d4e15e07 5356b422f65bdad1c3e9edca5d74a1ae 956c448bddc7e1f3585373687602379f 6f1456866eed87488c0f02b298a741c0

Email subscription for changes to this article
Save as PDF